![]() Simple controllers may not come equipped with these switches though. You can use this to preset the direction of flight as well as the altitude of flight. There are other smaller switches on the control panel that are used for setting the defaults for flying the quad copter. The right most stick is responsible for the pitch and roll controls, where the pitch represents the up-down motion while the roll represents a side-to-side motion. It is evident that this side-to-side motion represents the yaw. Its position in the middle is strategic to enable a side-to-side movement of the copter. ![]() The default position of this stick is down and in the middle. The left most stick on the controls is responsible for adjusting the altitude and the yaw. The other thing you need to know is how to use the controls. If you are a beginner, you would want to fly the copter at low altitudes where you can exercise greater control over the flight dynamics. The roll makes it possible for you to maneuver the copter either to the right or left side.Īltitude : this is the height at which the quad copter is flying. Roll : refers to the side wards movement – either left or right, of the copter. Likewise, to move it backward move the stick towards you. To move the quad forward, all you need to do is push the stick forward. The pitch is what determines the motion of the copter whether it is advancing in your direction or away from you. To move forward or backward, either the front or end tail should be higher than the other. Pitch : refers to forward or backward motion. ![]() The flight controls will be reversed if this rule is not followed. This makes flying of the copter easy since both you and the copter will always be facing the same direction. The front end of the copter should be such that it is facing away from you. Yaw : This is the direction along which the quad copter faces during flight. In order to fly the copter you need to get to know the lingo and jargon pertaining to the quads. You might also want to be aware of laws – both local and state – and make sure you don’t end up in hot water because you were ignorant of some law. ![]() In the case you want to fix the quad for some reason, unplug it before you start since it will only take a press of the wrong switch to badly injure you. Nonetheless, the pain will be unbearable as hell so watch out and do not injure yourself. ![]() The extent of injuries that you will sustain if your fingers cross the path of the blades will depend on the power of the machine in question. You have to ensure that your fingers do not get too close to the blades. Learning to cut the throttle in an instant is a skill that will stand you in good stead. If a crash is all but inevitable, you would want to cut the craft’s throttle down to zero before hitting the ground so as to prevent breaking the quad. The first safety precaution that you have to take – in case the drone you are flying is slightly larger than the size of a dinner plate, would be to tie the copter down to the ground or fly it inside a cage so as to protect any by-standers. You need to stay safe and protect by-standers in case you are forced to do an emergency landing. Safety is the first thing that needs to be addressed when flying a quad copter. More so for someone who is a beginner and is just getting started with quadcopters.Īssuming you have chosen a quadcopter that’s right for beginners, here’s a short guide that will walk you through the steps … Flying a quadcopter is certainly no walk in the park. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |